×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #360180

Member Since: September 10, 2012

Country: United States

  • I swear, the radioactive atom is right here, just don't move, my soldering iron will take care of it.

  • Bought the cable, and I have been trying to get it to work with an "arduino" I made (I whipped up an ATMega328p with headers, reset switch, and 5v regulator), and I conected GND to GND, VCC to VCC, RXD on cable to TXD on ATMega, and then TXD on cable to RXD on ATMega, and finally RTS to reset, but when I try uploading, I see that it resets because my blink program starts again, but then in the Arduino IDE it fails with

    avrdude: stk500_getsync(): not in sync: resp=0x00

    Any ideas?

  • This might sound a bit silly, but does a resistor work the same way if you have it hooked up to ground? I've always done +V -Resistor-LED- V- not V+ -LED-Resistor- V-

No public wish lists :(