Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you


Member Since: April 1, 2008

Country: United States

  • Product DEV-00762 | about 3 years ago

    Found my answer in the quick start guide. And the answer is YES.

  • Product DEV-00762 | about 3 years ago

    Hi, purchased one of these and had it up and running. Upgraded to FW 1.4.8 and everything was working fine until I tried to load my own HEX.
    I turned WDT off in the project and tried programming it. It gave me a warning asking whether or not I want to use my config bits (Yes), the board’s (No), or the current (Cancel). I selected “No” but then it failed anyway… Now my PC can’t recognize the UBW and the UBW no long has the flashing LED’s for programming (both Power and S2 led are on solid).
    Did I brick my UBW? Thanks…

No public wish lists :(