×

SparkFun’s ISP (internet service provider) is currently dealing with degraded network performance. While this is being resolved, you may see intermittent issues on our site and we apologize for any inconvenience. Please direct any issues or questions about orders to support@sparkfun.com. Thank you for your patience!

Jermtown

Member Since: September 22, 2012

Country: United States

  • I ran out of memory and had to shift to a SAMD, any suggestions getting to work with the SAMD? I’ve tried switching the switch to HW on the shield but not luck

  • UART communication in the MEGA2560 isn’t via the same pins…duh

  • Did you get an answer on this? Mesh networking with BLE would be great for a project I’m working on.

  • I’ve tried this with two different routers based on other comments I read. I get the same Error with both routers.

  • I have tried resetting and reprogramming but continue to receive the below message only. I made sure to leave the UART switch in the SW position. Using Genuino MEGA2560, power light is solid, and stat is blinking.

    Error talking to ESP8266. Error: 0 Looping forever.

No public wish lists :(