×

SparkFun Electronics will be closed in observance of memorial day on Monday, May 29th. We will resume normal business hours on Tuesday, May 30th. Any orders placed after 2pm Mountain Time on Friday, May 26th will process and ship out on Tuesday, May 30th.

Member #370408

Member Since: October 16, 2012

Country: United States

  • I went through and measured the screw hole pattern and made a drawing of the positions. I also made a drawing of the outer profile (slightly inset from the profile of the device). I used 8-32 screws to mount it, but I think M4 screws should work as well. I made a 3D FDM part using these dimensions and verified it fit. Take a look:

    screw dimensions

    other dimensions

    If you do an inlet on the intake side, use a filleted inlet with a radius of at least .2*Diameter (12mm), as this design will produce the lowest entrance loss.

No public wish lists :(