×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #372555

Member Since: October 23, 2012

Country: Netherlands

  • I have the Roving-Network rev3 unit (https://www.sparkfun.com/products/10822) and this unit. With these two units i wanted to setup a base station to control a Arduino.

    But it seems not to work as i cant get in contact with the WIFI unit true the serial interface. Anny suggestions?

  • It looks that also the schematic is not correct. It shows 8 pin on the header as the board has 9 pins header.

  • I have to put it on a other PCB. Where can i find the footprint?

No public wish lists :(