Member #376426

Member Since: November 5, 2012

Country: United States

  • Can someone point me to instructions for configuring this board to run at 8Mhz? I want to see if my project will work on an Arduino Pro 3.3v before I acquire one.

    I have found hints e.g. "set the fuses", but nothing like a how-to.

    Thanks in advance! (and afterwards, too)

  • Do the mounting holes on the Pro match up to the holes on the original Arduinos? I want a 3v Arduino that can be solidly mounted to a standard shield, but to my eyeballs the holes near the power connector don't match.

    If I made custom shields, perhaps I could put both holes in my shield so it would work with either Arduino?

    Any advice would be appreciated. Thanks!

No public wish lists :(