×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #377293

Member Since: November 8, 2012

Country: United States

  • LOL my bad stall current

  • Hello all I am using an ED v4.4 with the Arduino Mega 2560. I was trying to get full steps and 1/4 steps, but when I connect MS2 to gnd the motor stops. When I connect enable to gnd the motor still runs, i thought the silk screen might be switched but steps seem un-effected. MS1 seems to be the only pin that effects my step size. Has anyone else run into this?

    Thank you -N

No public wish lists :(