×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #388076

Member Since: December 10, 2012

Country: United States

  • I recently purchased the RN-41 bluetooth module. setup was somewhat a breeze and the range is fantastic. I have everything working perfectly except one issue I cannot seem to resolve. I need to use the general purpose I/O (just one of them). I chose pio7 and set the pio register to make 7 an output upon powerup. my software in CMD mode sets gpio 7 high (which is pin4 on this module). Once the cmd is issued ,the pin raises to 3.3v (as expected) then fluctuates from 1.1 to 3.3v in a pulsing manner. The DC level isn't a stable logic high. Has anyone else had this issue? If so, is there a solution or something I am overlooking in the setup? perhaps low power mode or something like that?

    Any help would be appreciated as this is holding back my project.

No public wish lists :(