×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

3M

Member Since: May 18, 2008

Country: United States

  • For anyone still struggling to get the drivers working with Windows 7 64 bit, just download the libusb drivers from BeagleBoy's post (first one). Unzip them, and run bin/inf-wizard.exe. It will generate an .inf driver file which it then installs for you. Windows complains that it doesn't know who made the driver, but it still installs and works fine.

  • It's rather annoying how the pins aren't wide enough to span the gap on a breadboard. It means that I have to connect it to the breadboard with just plain wire instead of a header pin like some of these. It makes it really unstable and a pain to disconnect and reconnect.
    Does anyone else have this problem/found a way around it?

  • https://www.sparkfun.com/commerce/tutorial_info.php?tutorials_id=93 should help.

  • I'm having the same problem as other people, but unfortunately after verifying my caps are correct I still have the problem. It was working until I ran the command 'avrdude -p m168 -P /dev/ttyS0 -c ponyser -U lfuse:w:0xe6:m' and the LED stopped blinking. My Atmega168 is now "not responding". I'm certain I have 22pF caps before my crystal, and there is ground going through the crystal (hooking up one lead to VCC and one to a leg of the crystal gives me ~5V). Does anyone know how I could save my Atmega?

  • I agree, I'd rather just have the breadboard.

No public wish lists :(