×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

RicoBravo

Member Since: May 27, 2008

Country: United States

  • When will the base plate be ready?

  • I would recommend anybody getting into microcontrollers to use the Arduino, but I will say the book that comes with this kit is really good. I would recommend the book with an arduino board instead. You can download a free PDF of the book from parallax. Lastly, check out the Parallax website they have some really good sensors.

  • I got these bad boys working. Make sure to set your baud rate to the baud rate you are operating at in the Serial window of the Arduino software. I forgot to do this and was scratching my head but as soon as I did this I verified the data was correct!!!

  • Nathan,
    You should think about moving the TX and RX lines from the Xbee socket to pins 2&3 of the Atmega168, so a person can access the serial port and transmit commands at the same time. This is very useful when trouble shooting. Ladyada's softserial will allow pins 2&3 to act like TX and RX.
    Thanks
    -Jose

  • Hey,
    This should be fun, can't wait to see the following classes!

No public wish lists :(