×
SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.
×
Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
ta anders
Member Since: February 3, 2013
Country: United States
-
where is the non-retail version?
-
these should have a link to the new hakko cutters.
-
how do you detect a button release, as opposed to a press? e.g. in the example code, if i press "A" the Serial Monitor doesn't keep streaming "A" over and over, it only registers one per press. In my case I want a motor to run and then stop when i let go of the button.
-
Dumb question here... Which way does the battery go in? It fits both ways... Also is this reverse voltage tolerant? :)
EDIT: got it! + is towards the ground, and - points up.
-
IMO the tip needs to be flexible, not hard because i can never get a good seal before the solder re-hardens. :( does anyone have any tips?
-
I just KNOW that i will lose the 2mm pieces the minute I open the box.
-
EDPM rubber rollers. read the datasheet.
