Frequently Asked Questions
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
Chat With Us
February 7, 2013
about 9 months ago
Thanks! This is the part. We just fill the divot with enamel paint.
about 2 years ago
The Eagle files are linked above under documents but here are images of the schematics and PCB.
What are you plugging it into? Have you tried headphones? Are you sure all of the soldering is good?
No it shouldn’t make a hum unless you are rubbing the bottom side of the PCB.
Have you tried a new cable?
It does not have a noise mode.
Were they not in the bag? They might have fallen out of the knobs themselves.
It will have a small notch cut out of the side of it as seen in step 7. The longest pin should go into the second pin from the left. You need to bend the leads a little to get them in the holes.
about 3 years ago
What version of Arduino are you using? What Chip?
It compiles fine for me on 1.0.1 with a standard 328
Yup! We just use enamel paint pens.
No public wish lists :(
Forgot your password?
No account? Register one!