×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

Member #407941

Member Since: February 11, 2013

Country: United States

  • Product SEN-10736 | about a year ago

    I tried to load a simple blink sketch using IDE, selected Arduino pro or pro mini 3.3v/8Mhz ATmega328. still the same problem: avrdude: stk500_paged_write(): (a) protocol error, expect=0x14, resp=0x24 avrdude: stk500_cmd(): programmer is out of sync Same error as I want to flash the Test Firmware. Which means I got a defective IMU? Thanks again, a1ronzo.

  • Product SEN-10736 | about a year ago

    Thanks a1ronzo,

    I linked my 9DOF IMU 10736, with a FTDI 3.3v board connected to USB via COM5. I’ve downloaded the directory which contains .hex file from your Test Firmware link ( Do I need execute ‘make all’?here I didn’t). Then installed WinAVR program. Then I tried with following command within 1sec after pressing reset on the board: C:\Users\username\Desktop\SparkFun-9DOF-Razor-IMU-Test-Firmware-master>avrdude -p m328p -P COM5 -b 57600 -c stk500v1 -U flash:w:main.hex

    in the attach, you can find an error screenshot, always something like: protocol error, expect=0x14, resp=0x24. programmer is out of sync.

    The error is the same as I want to write in with AHRS code.

    Do you think that was a problem of the hardware?

    thanks alot

  • Product SEN-10736 | about a year ago

    Thanks a1ronzo, I bought a FTDI with 3.3v (DEV-09873). So I was using the correct FTDI board. I will try to solder some headers and use jumper wires with avrdude. But, i have another question: When I tried with AHRS code, I changed HARDWARE OPTION to 10736 and selected correct board and COM, then uploading code via FTDI to 10736, it replies me an error: avrdude: stk500_paged_write(): (a) protocol error, expect=0x14, resp=0x24 avrdude: stk500_cmd(): programmer is out of sync

    Do you think if I can reinstall TestFirmware, I can fix this problem?

  • Product SEN-10736 | about a year ago

    I have a question regarding to re-install Test Firmware on this board. As I know that my 9dof IMU board comes with Test Firmware (I can see the v22 menu, but when I selected 1,2,3,4,etc, it always reply me Firware Menu. There’s no data). Is that a problem of my board? I tried to connect this board to Duemilanove with AHRS code, it always gives me 0,0,0. So, I would like to try with 9DOF AHRS directly using FTDI breakout board. But, it gives me error: avrdude: stk500_paged_write(): (a) protocol error, expect=0x14, resp=0x24 avrdude: stk500_cmd(): programmer is out of sync

    What is my problem? How can I reinstall (flash) the Test Firmware back? thanks

No public wish lists :(