Member #408334

Member Since: February 12, 2013

Country: United States

  • Since the clock worked I moved on to use the FTDI breakout and soldered a male header to the serial board. In checking which way to plug in the FTDI breakout I noticed that the pin sequence did not match. Serial board: DTR, TX0, RX1, 5V, GND, GND FTDI board: DTR, RX1, TX0, 3V3, CTS, GND Is this simply transmit connected to receive and vice versa? And what about 5 volts to 3? volts? Dave

No public wish lists :(