×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

Member #410789

Member Since: February 19, 2013

Country: United States

  • Product DEV-09473 | about 7 months ago

    I just purchased this as a replacement for an official Ethernet Shield on an Arduino Mega. The comments here are a few years old and were specific to a board other than the Mega, so I thought I’d share an update.

    Arduino Mega R3: J1-1 to D51 (MOSI) J1-2 to D50 (MISO) J2-1 to 3.3v J2-2 to Reset J2-3 to D52 (SCK) J2-4 to D10 (SS) J2-9 to GND

    The important point is that the Serial Slave pin assignment for the Mega is D53, but for some reason the IDE/Software is still using D10 per the Uno.

No public wish lists :(