×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

gego

Member Since: March 3, 2013

Country: United States

  • Product WRL-10854 | about a year ago

    Should this work with the RN-XV WifFly? It’s recommended on the product page, but for me, the example sketches all get stuck at “Attempting to connect to SPI UART…”. The WiFly is getting power, the DIO5 LED is blinking at a constant rate on the shield, and I’ve run through the relevant pins (I believe) to check my soldering job for continuity (I’m using the correct shield headers).

    I need to set the switch on the shield to DLINE to upload the sketch, and have tried switching it back to UART and rebooting the Uno to see if that was the issue, but still no luck. I’ve also tried running the HardwareFactoryReset sketch (this is all brand new equipment, but worth a try), but it also gets stuck at the same point.

    Any help is appreciated.

No public wish lists :(