Member #417280

Member Since: March 9, 2013

Country: United States

  • Product SEN-10703 | about a year ago

    Thanks for your response Kyleser. I am using an Arduino Uno and, although I thought I checked the baud rate, I’ll check it again. I’ll also follow up with your other suggestions. I did notice something that seemed odd. When I check continuity across the SCL and SDA pins, I get continuity. I’m not sure if this should be the case. I thought at first it could be from my novice soldering skills so I unsoldered the puns and there was no change. Anyway, I’ll check all your suggestions and get back.. Thanks for your help.

  • Product SEN-10703 | about a year ago

    I recently purchased the LSM303DLHTR breakout board. I connected Vin to 5V, GND to GND, A4 to SCL and A5 to SDA. I also used the code example give above. I was able to compile the sketch but when I try to upload it, the serial monitor reacts as if nothing is going on. Any thoughts on what I might be doing wrong? I’m new to Arduino and don’t have the best background. Any help you can provide would be appreciated.

No public wish lists :(