×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

avatar

slptrains

Member Since: March 11, 2013

Country: United States

  • Additional Information:

    Unit is driving a Mercury Stepper also purchased from SF, and the power to it is from the Arduino's 5v regulated output port. If I use the Vin port (12v), the stepper and the driver become very hot. I am using the Accelstepper.h library, and have the speed and acceleration set at 400 max, and 250 accel.

  • I am using the ED with an Arduino Mega to automate a device that depends on precise positioning. However, when I use a 12v 5amp power supply in the Arduino, everything works find. When I replace the power supply with a 12v 2 amp unit, the stepper creeps a bit before the initialization is complete, but enough to screw up the positioning. Any ideas?

No public wish lists :(