We are still shipping! However, order processing may take longer than usual and we cannot guarantee same day shipments due to staffing guidelines from the CDC. Please see all COVID-19 updates here. Thank you for your continued support.
Track My Order
Frequently Asked Questions
International Shipping Info
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
Chat With Us
March 16, 2013
Tutorial - Setting up an EL display with the EL Escudo Dos
about 5 years ago
Actually, I just tried the sequencer with 20ft of wire, and if I turn on the EL wire for more than 1-2 seconds, then I can't use
digitalWrite(pinMode, LOW) to turn it off anymore. At the moment, I am making a default LOW for a couple of seconds after any HIGH just to make sure it doesn't stay on for too long. Is there a maximum length of EL wire that can be controlled by the sequencer? Thx
Great thanks! I just got my sequencer and I've tested it with the teensy 2.0. Works well.
the 3V inverter should do..
Hi, I would like to use this sequencer with a Bare conductive touch board. It essentially works like an arduino but the board setup means I won't be able to plug the shield directly to this. Could you tell me which pins from the El Escudo need to be connected to the arduino board in order for for me to be able to program it? I will then just solder directly to the board. Thank you!