×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

tomdbin

Member Since: March 21, 2013

Country: United Kingdom

  • Product ROB-10333 | about a year ago

    I have several of these motors. At first I thought there was a problem as my initial experience was the same as several other contributors - eratic behaviour, jaming on the end stops, constant motion/oscilation etc.

    However, the problems were only apparent when driven directly from the Arduino UNO board - even with an independent power supply. On the scope the pulses intermittently have the trailing corner cut off, resulting in an inprecise pulse width.

    If you drive the servo from a Servo Controller or by powering the motor directly, then it works perfectly.

No public wish lists :(