Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you


Member Since: June 27, 2008

Country: United States

  • Product SEN-10586 | about 10 months ago

    Has anyone ever had any issues with one of these hanging? I have it plugged into a linux box, I connect using screen /dev/ttyUSB0 9600. I then get a “RESET” and nothing else. It hangs and does not accept a ctrl-z.

  • Product DEV-09802 | about 2 years ago

    ahh, I just answered my own question. I did not realize that if you don’t set it to output it can cause the SPI to go into slave mode.

  • Product DEV-09802 | about 2 years ago

    Isn’t there a typo in the descr? It says D10 needs to be set as an output right after it says CS is D8 on this board. It should read D8 needs to be set as an output, no?

No public wish lists :(