×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

RobV

Member Since: April 2, 2013

Country: Netherlands

  • Perhaps I am doing something wrong, but I need to connect OE to the VCCa in order to get proper logic levels. I didn't remove the jumper. The hookup guide shows the OE unconnected. Please advise.

  • The schematic uses 1k resistors on the pins, perhaps dropping that to 220ohm will increase the brightness? i'm hesitant with using 0-ohms because i am scared to fry the display!

  • Any idea when these will be back on stock? I can't find an alternative anywhere!

No public wish lists :(