Member #430322

Member Since: April 18, 2013

Country: United States

  • Product PRT-11231 | last year

    I have an Arduino Esplora that I’m going to use this with. If I run a 5V line from the Esplora to the 5V charge pin and also to the Vcc pin, will I be ok? I want the power from the Arduino’s USB connector which will be exposed to be available to charge the battery and when I disconnect it, I want the battery to take over.

    I will have a switch to allow me to turn off the system when it is not connected to USB and I know I’ll have to disable this board.

  • Tutorial - PowerCell Quickstart Guide | last year

    I have an Arduino Esplora that I’m going to use this with. If I run a 5V line from the Esplora to the 5V charge pin and also to the Vcc pin, will I be ok? I want the power from the Arduino’s USB connector which will be exposed to be available to charge the battery and when I disconnect it, I want the battery to take over.

    I will have a switch to allow me to turn off the system when it is not connected to USB and know I’ll have to disable this board.

  • Product WRL-11378 | about a year ago

    Why did you guys tie pin#4 high? I’d really like to use this at rates higher than 9600 baud, but that pin overrides software setting of baud rate.

No public wish lists :(