×

Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.

Member #430623

Member Since: April 19, 2013

Country: United States

  • I think I may be at a similar stage in my project to #424122. I've been having fun with the ADH8066 mounted on the evaluation module by using the USB and sending AT commands from hyper-terminal. I think I'm now ready to try and move on to providing commands from my uC (PIXAXE 20X2). Are you saying here that I need to remove the solder jumpers from the Tx & Rx pads adjacent to the FT232 chip. If I do this then I can use the pins labelled Tx & Rx (10 & 11 down right hand side)?

No public wish lists :(