Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
Member Since: July 16, 2008
Country: United States
Product SEN-10530 about 5 years ago
I just found an app note from Honeywell which states that pin 5 should be connected to VDDIO rather than the no-connect listed in the data sheet. They say it will affect I2C performance in a small percentage of parts if left unconnected. I'm having some I2C hiccups on mine, so I'm going to try adding a jumper.
If there is an opportunity for a design rev of the breakout, adding the pin 5 connection would be good change. As of April 2016, Honeywell has listed this chip as end-of-life, so it seems doubtful that this design will be around too much longer...
No public wish lists :(