Member #438162

Member Since: May 15, 2013

Country: United States

  • Product DEV-11113 | about 11 months ago

    I have this hooked up to an ID-20 for an RFID project but it doesn’t seem to be receiving data correctly. The sketch uploads correctly and everything looks fine until I scan a card and then nothing happens. I prototyped everything out on a breadboard UNO and it works fine if I plug everything up to it but not when I use the mini.

    I am following this build: http://www.instructables.com/id/Arduino-RFID-Door-Lock/

    Is there anyway to test the serial pin (RX) ?

No public wish lists :(