×

SparkFun Electronics will be closed in observance of memorial day on Monday, May 29th. We will resume normal business hours on Tuesday, May 30th. Any orders placed after 2pm Mountain Time on Friday, May 26th will process and ship out on Tuesday, May 30th.

Member #443705

Member Since: June 4, 2013

Country: United States

  • This would work I guess, but I consider it not very user friendly. For a next revision I propose to place the breakout pins to the left and right (not top and bottom) of the breakout board. Then it can be used in “landscape” orientation and jumper wires can be easily used.

    The breakout board for the rotary encoder RG is better in this sense (jumper wires can be used on both sides), except that the breakout pins are not properly lined up.

  • You are right that this board fits on a breadboard. However, it is too long, so that only one side (either [GND, SW, R, R] OR [A C B]) can be connected using jumper wires next to the breakout board. So, unfortunately it is useless on a breadboard.

No public wish lists :(