×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

Member #446367

Member Since: June 13, 2013

Country: United States

  • Product SEN-11028 | about 11 months ago

    Hi! I’m using this sensor with my arduino mega and i have some weird problem:

    The connections between arduino and IMU are: VDD - Arduino 3.3v GND - Arduino GND INT - leave unconnected FSYNC - leave unconnected SCL - Arduino SCL (dedicated pin 21) SDA - Arduino SDA (dedicated pin 20) VIO - Arduino 3.3v CLK - leave unconnected ASCL - leave unconnected ASDA - leave unconnected

    When I run the MPU6050_Raw sketch it says connection failed. I try to connect de VDD and VIO pins to 5V and it works fine. I use this connection only once and for 2-3 minutes to not damage the chip. Should i use the sensor with this connection to 5V pin? Anyone have suggestions?

    Thanks!

No public wish lists :(