×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

cristi-ev

Member Since: July 6, 2013

Country: Sweden

  • after working a bit with the UART, both RX and TX LEDs are lit continuously and I cannot get any response from it. I guess my board is gone, I wonder what should I do to avoid this situation with the next OBD-II UART board I buy?

  • About

    You'll also need a way to power the Arduino while it's in your vehicle since power can't be taken from the OBD-II-UART board

    The VBATT pin on the board is connected to the OBD-II VBATT, i.e. to the car battery. Is there any problem with taking power from there to my Arduino application? It's not the OBD-II UART giving power, but the car itself...

No public wish lists :(