Member #452266

Member Since: July 6, 2013

Country: United States

  • Product PRT-10811 | about 10 months ago

    Does anyone know if these will work on a board printed by OSHPark using the correct layout, but with standard sized pin-holes instead of the slots? I have the other barrel connector with the wider leads, but just received my boards from OSHPark and I see that they just have standard holes drilled without enough room for the fat leads on the other connector.

    I’m hoping that the posts on this one might fit in to the standard holes on my PCBs, but I can’t seem to figure out the dimensions for the pins on this from the drawing. Thanks in advance!

No public wish lists :(