×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #454903

Member Since: July 17, 2013

Country: United States

  • Ran into something rather strange. I'm using the Attiny85 to run a motor control chip but couldn't figure out why pin 0 wasn't working. Changed to pin 1 and 2 and it works OK. Changed back to pin 0 and 1, programmed it and took the chip out of the programmer and it works fine. So I assume it has something to do with the LED on the programmer but I would think it is small enough current that it shouldn't be a problem. Anyone else have this problem?

  • I would like to use a Beaglebone Black to control multiple Arduinos via ethernet (basically transferring data back and forth). Can someone give me some pointers or a tutorial on the best way to get started?

No public wish lists :(