×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #455221

Member Since: July 18, 2013

Country: United States

  • I'm having trouble using this board with Ethernet shield. If someone can point me how to properly set pins I would be grateful. Ethernet part of my sketch works fine, but when I add RFID board, there is some obvious pin collision because, even if I don't setup RFID sketch parameters, "found" LED activates at the same time as "TX" LED on Eth. shield. Thanks in advance!

No public wish lists :(