SparkFun will be closed Nov 26th and 27th for the Thanksgiving holiday. Orders placed after 2:00pm MT on the 25th will ship out Monday the 30th.


Member Since: August 14, 2008

Country: Canada

  • Hi
    This board has been really nice to work with for the most part.
    I have a couple of suggestions that may improve it however:
    1: line up the break out pins such that they are on a grid that would fit on a large prototyping board. They are slightly out.
    2: Label the solder joint (SJ) pads with their numbers. Since these are all connected to GND it is impossible to identify which is which using a continuity tester, and following the traces is pretty hard as well. (If you published the layout that would help)

No public wish lists :(