Member #457101

Member Since: July 25, 2013

Country: United States

  • Product DEV-09530 | about 8 months ago

    Gentlemen,

    I am trying to log nema0183 directly from the gps unit to the openlog. Seems pretty straight forward with the advent of this dandy little Openlog unit. I have verified the outputs of two gps units with an ftdi 232 to usb board. Both units stream perfect sentences to the terminal screen. I am watching the 0-5v nema burst on the scope and verify that the open log blue led is active during each burst. BUT… my openlog file is full of ascii nonsense. i have discovered that 19200 is the minimum for proper nema sentence output to the terminal, unlike the 4800 nema spec. i have tried every baud rate, matching the openlog config to the gps setting without success.

    Any suggestions would be a great help. Thanks!

No public wish lists :(