×

SparkFun will be closed May 25, 2015 for Memorial Day. Orders placed after 2pm on Friday the 22nd will ship out on Tuesday. Thanks!

Member #470881

Member Since: September 18, 2013

Country: United States

  • Howdy –

    How would I go about using this to communicate w/my Arduino via my computer? I feel like I’m close but am not sure what to do with the RST and NC pins. I’ve got the BT’s Tx pin hooked up to the Arduino’s Rx pin, and the BT’s Rx pin hooked up to the Arduino’s Tx pin (via a voltage divider).

    The code I am trying to test is located here: http://www.instructables.com/id/Cheap-2-Way-Bluetooth-Connection-Between-Arduino-a/step2/Load-the-Arduino-test-sketches/

    Basically there are two problems that I’m running into (due to my lack of knowledge of BT connectivity): 1) I’m not sure what to do with the RST and NC pins on the BT module. 2) I’m not sure if I need to modify the code from above/in what way I should modify it.

    Any help is much appreciated! Thanks in advance!

No public wish lists :(