SparkFun will be closed Nov 26th and 27th for the Thanksgiving holiday. Orders placed after 2:00pm MT on the 25th will ship out Monday the 30th.

Member #480551

Member Since: October 20, 2013

Country: United States

  • I am looking to use three of these with a GRBL-arduino setup. It appears that will work ok per the GRBL documentations. However, I am wondering if I could change this up and get a parallel breakout card and then use these with a LinuxCNC/EMC2 setup. I am trying to be flexible in the design so I could move to LinuxCNC if I need the extra complexity. Anyone had experience in either of these configurations?

No public wish lists :(