Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #482824

Member Since: October 28, 2013

Country: United States

  • Can you share a link to the code you got working?

    I’m trying to get this working on a Particle Photon.

  • Did you ever get the library working for this sensor?

  • No, I’m not sure what the minimal code is to get the UART library to run on an Arduino Uno just to see it working.

    Can somebody at Sparkfun please provide a sketch that works and compiled with the Arduino Uno without all other nonessential stuff in the library removed? It would really be helpful for a lot of us who bought this sensor.

  • I'm received this sensor but can't get the Arduino library setup to correctly compile to run on aan Arduino UNO.

    Can anybody share what is working for them if they have this running on an Arduino device please?

    Looks like a great sensor, all my other voc, temp and humidity chips from them work perfectly

  • It would be nice to have the lenses included so we can test the difference with and without. I'm not seeing much signal past like 1 meters for a normal person wearing clothes. I think the lens would help with the IR gain as the datasheet says.

    Is there a way to increase the Gain via code to increase the sensitivity?

    Where can get the lenses? Could you guys send me one, I bought the sensor.

  • Where can I find the datasheet for this chip that has the register map info in it?

    I'm trying to figure out exactly how to use the SetPeak and SetThreshold settings to have the sensor trigger the INT pin while in standby mode.

    I'm not exactly sure what the Peak & Threshold settings stand for.

    Any help is greatly appreciated!

  • It would be nice if the Interrupt pin on the sensor could be used to wake up a sleeping Micro Controller to then send the notification of the movement.

    Is there any reason the Interrupt in was not added to the library?

No public wish lists :(