×

Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.

Member #487186

Member Since: November 10, 2013

Country: United States

  • I want to drive OpenLog from a 5V Arduino Pro Mini. The header is the OpenLog source file says "Input voltage on RX-I pin must not exceed 6V". The datasheet of atmega328p says max input voltage VCC+0.5V which is 3.8V given the 3.3V VCC. Can I drive OpenLog from a 5V MCU without a level shifter?

  • I am looking at the schematic, the atmega328p runs at 3.3V and 16Mhz. According to the atmega328p's datasheet this is outside the spec (13.33Mhz max at 3.3V). Am I missing something?

No public wish lists :(