Member #487587

Member Since: November 12, 2013

Country: United States

  • Product SEN-11836 | about 2 months ago

    The sensor must be connected directly via USB. When USB connected, the scanner will populate on your computer as a mass storage device. Once the computer has registered the mass storage device, you will be able to connect to the software and begin registering your fingerprints.

    Just connect the V+, V-, D+, and D- lines from a USB cable to the back of the scanner as shown explained below and launch the GT-511C1 software as normal.

    The connection of the sensor from the back side with the USB connections starting from the pad near to (J1) and go down: 1 - Red. 2 - White. 3 - Green. 4 - Black.

    Hope this helps,

  • Product SEN-11836 | about 4 months ago

    Hi everyone, i have bought GT-511C1, the problem that the software didn’t work with it, i can’t choose the port for it, and i need the software urgently as i use it in my graduation project, so could anyone help me with this. or if any one know the preprocessing type that this sensor use.

No public wish lists :(