×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Ramza

Member Since: September 26, 2008

Country: United States

  • You can simply comment this out in the Openscale code. Look for setting_tare_point = (long)8647409; add // to comment it out

  • Yes, I was able to do this. I used an arduino uno and I connected the Serial out of the Openscale to the arduino. So GND <-> GND, and the TX of Openscale to RX of Arduino.

    For your code, just do the regular Serial setup for 9600 baud, and do Serial reads for the data.

No public wish lists :(