Member #510084

Member Since: January 17, 2014

Country: United States

  • I have a Doepfer CTM64. It has 64 contacts and a common, and when the circuits are joined by a momentary switch, pressing the switch (closing the circuit) sends a Midi note-on message. I'd like to make a momentaryswitch which has as little tactile feedback as possible (I don't want it to 'click' when I press it). Would it be possible to use the force sensing resistor as a momentary switch?

  • I was wondering if it's possible to trim down the sides of the ribbon to make it a bit thinner? I need to mount two of these side-by-side in a tray about 35mm wide. This means trimming the sides of the pots down. Would that just destroy them?

No public wish lists :(