×

It is that time again! SparkFun Electronics will be closed Friday, January 13th for our annual inventory day. Please keep in mind that any orders placed after 2PM (Mountain Time) on Thursday, January 12th will not ship or be prepared for local pickup until we open for normal operations on Monday, January 16th. In addition, tours will resume on Friday, January 20th. Thank you for your patience!

avatar

Member #516514

Member Since: February 3, 2014

Country: Romania

  • That’s some expert troubleshooting right there, You realize you’re supposed to slide the collars to adjust the angle, right?

  • The screws used to screw the claw to the tilt/pan bracket (M3*10 in the diagram) are way too long for me. Before you ask, there’s nothing else on my desk, everything else seems to have a place and would be even longer or too short if I tried to switch them around. And, yes, I did use the M3 nuts. Judging from the comments and the images above, I guess they packed the wrong screws in my case.

    EDIT: I am now confident of this as I have two sets of identical screws, four each. That’s not what they show in the image. However, I ordered M3*30 screws from another place and they are just a tiny bit too short so now i can slide the claw at will. This is annoying. What a trash product.

  • I should have studied the board carefully before asking that question. It does have those pins, except they are in the middle of the board.

  • Is this compatible with the Arduino Pro Mini? It has neither SDA/SCL nor A5/A6 pins. Thanks.

No public wish lists :(