×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #519277

Member Since: February 10, 2014

Country: United States

  • I have had good luck with these boards. I think I have had one failure out of 27 I have purchased. However , you need to be aware that if your Uno, etc is already using pins 2 or 3 (e.g. motor driver board) you need to cut the pin(s) (I use a Dremel) and jumper/ reroute them to another pin(s). For example : since I'm using Serial3 on a Mega board, I rerouted X-Bee pin 2 to Mega pin 15 (Rx) and pin 3 to 14 (Tx). Also, since the headers have to be added, I printed two fixtures to hold the headers in alignment while I soldered them (I have a 3D printer). It only takes ruining a $30 motor driver board to get smarter ;)

No public wish lists :(