×

Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.

Member #519494

Member Since: February 10, 2014

Country: United States

  • Correct! I got that info from the manufacturer, but forgot to come back to post the answer!

  • Been messing with this a bit. I have the breakout board and it works great. From what I can tell, for bare bones operation, all I need to connect is:

    PIN 1 (Ground) -> Gnd
    PIN 34 (3V3_USB) -> 3.3 V regulated power supply
    PIN 41 (UART_TX) -> MCU RX
    PIN 42 (UART_RX) -> MCU TX

    Is there any other logic required? I can't get it to cycle on.

No public wish lists :(