SparkFun will be closing early at 3:30 Friday 5/27 and remain closed Monday for Memorial Day (5/30). Orders placed after 2pm MT on Friday (5/27) will process and ship out on Tuesday (5/31).

Member #522145

Member Since: February 18, 2014

Country: United States

  • Hi,

    I recently buy this driver, with a NEMA 23 stepper motor, and with Arduino, I have tried to move it, but I can not. I have used a circuit similar to reprap 3d printer (Arduino controls ENABLE, DIR and STEP) and the other pins are fixed, but the motor does not move. I have noticed that the voltage regulator, it is heated up, so I think this component is damaged. Is there any way to check I am correct? Are there other explains? What is exactly the voltage regulator for replace it?

    Thank you very much, Antonio.

No public wish lists :(