Member #524498

Member Since: February 24, 2014

Country: United States

  • ok i got it working. $$$ has to be sent with no newline….and then all commands there after with a newline…now i have bluetooth working; however everytime i try and control the wildthumper, the trex board right motor fault light turns on…..only can power the left side….tested the motors they all seem to be fine….any insight??

  • Still not working….

  • I will give that a try. Thanks for the quick reply. Are you aware of the serial commands for this module? I was trying to get it into command mode by letting the trex send $$$ but the middle didn’t reply “cmd”, or maybe I don’t know how to monitor its reply….

  • i am trying to use a bluesmirf gold myself and cannot seem to figure out how to use the Trex board to configure the BT. what did you modify in the bluetooth sketch provided with the trex controller?

No public wish lists :(