×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

TMRobotics

Member Since: March 20, 2014

Country: United States

  • FYI I've had Luck sawing this board in half to create a remote antenna. I left the the trimmer capacitors on the antenna half and brought ground and the two antenna lines direct to the SM130 module pins. In my case these pass through a DB25 cable (Antenna ground is connected to the cable shield at both ends). It's a little hard to explain without detailed build instructions. Performance appears to be largely unaffected but I've modified all the boards that I have so a side-by-side comparison is not possible. A handy mod to the next rev of this board would be to make it perforated so the user could easily relocate the antenna.

No public wish lists :(