×

Prolonged severe weather across the U.S. is causing delays including the ability to transport and deliver packages in certain cities. Please see here for more details. Thank you for your continued support and patience.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #536248

Member Since: March 27, 2014

Country: United States

  • I had a similar issue. I found that connecting an FTDI directly to the GND, VCC, TX, RX pins and then I was able to get serial IO.

  • I have to say, it took a bit of time to get this working, but I finally was able to. Some issues I had: when using the Beefy3 FTDI board, I was only able to see serial output using the Arduino serial monitor. In order to use other terminal programs, I had to connect a UART to VCC, GND, RX, TX and then I could get serial out. Also, I found the LED builtin pin was #2. Very fun!

No public wish lists :(