×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #539793

Member Since: March 29, 2014

Country: United States

  • Spent a good chunk of time, trying to get the baud rate on this to change while using UART. I've used the command to write to it, and then the baud rate. Like this:

    Serial.write(0x7F); // set baud Serial.write(0x06); // to 57600

    For the LIFE of me, i can not get this little guy to change baud rates... Maybe im doing something wrong? Also on the hookup guide, its kind of misleading with the pictures, because for SPI and I2C the labeling doesn't match up with this board. Where am i supposed to plug in for those other two protocols? maybe i wouldnt even have to worry about changing the baud rate, so i can use the other device.

No public wish lists :(