Member #546939

Member Since: April 19, 2014

Country: United States

  • Thus far I’m unable to get enough volts to power the APM board using ports A1/A2/S bar with this product however I’ve tested with a few 5V UBEC and SBEC’s and they provide plenty of power to power up the APM/GPS/RX…etc. I’m still trying to figure out if I’ve got 2 bad boards from SparkFun or what.

  • Hello, I’ve ordered two of these one for my hex and one for a friend. We both followed the video and came up with the same results. We’re getting proper voltage on the main PDB board however only getting .7v to the APM. We’ve tested with 4 different batteries ranging from 3-6S. Nothing is putting out more than .7V on the output of the AttoPilot to APM thus not powering the APM. Do you have any advice for us? Thanks!

No public wish lists :(